Tag Archives: dummy load

Constant Current Dummy Load

_MG_0942

This is a constant current dummy load. It’s controlled by a PIC16F1936 microcontroller. As you can see, it’s equipped with a 4×16 character LCD display and, less obvious, a rotary encoder with push button. It accurately sets the desired current via a 16bit DAC and reads both current and input voltage with a single-channel 16bit ADC each. Temperature is measured by the microcontroller’s internal 10bit ADC.

_MG_0933

It needs a 6…16 volts supply for it’s own use. That’s what the upper pair of banana plugs is for. It can then burn up to 4.5 amps in the range of 0…22 volts. You can set any current from up to 4.5 amps in 1mA steps via the rotary encoder. By pressing the encoder you can set the ‘sensitivity’ of the encoder. There are 3 ranges: 1mA, 10mA and 100mA per (encoder) step. This way, you can quickly and precisely set any current you want.

_MG_0934

There is a LM35 temperature sensor mounted directly to the heat sink. The temperature is shown on the display as well as used for protective purposes. The software automatically limits the current if the heat sink gets too hot. Using the temperature, current and voltage, it also calculates the die temperature of the two MOSFETs and makes sure their temperature rating is not exceeded. They have a temperature rating of 125 degrees centigrade and a die-to-heatsink thermal coefficient of around 4 degrees/Watt. So with higher voltages and currents it’s entirely possible to blow the MOSFETs even with moderate heat sink temperatures.

_MG_0935

You might wonder what the Xilinx XC9572XL CPLD is doing on there. Well, this was my very first project involving an LCD display, my first project involving a rotary encoder, my first project involving external ADCs and DACs… My first project at a lot of things. So I appreciated having the flexibility to change some of the signal routing in VHDL. All the signals traveling from the rotary encoder to the microcontroller and from the microcontroller to the display travel via the CPLD so I can re-route those signals any way I want. Now the CPLD mainly takes care of the encoder

The 100mil header at the front is a I2C interface that let the dummy load communicate with the outside world. It was added later so i had to run some wires to get access to the I2C bus.

By the way, this is how I got the idea of building a dummy load: http://www.eevblog.com/2010/08/01/eevblog-102-diy-constant-current-dummy-load-for-power-supply-and-battery-testing/

Simple, resistor based Dummy Load

Another afternoon project. Some time ago I was working on a 80 watts 12-to-36 Volts DC-DC boost converter. Not one of my most successful projects but anyway.

_MG_0936

So I needed some kind of load but my home made constant current dummy load can only handle 20-something volts. A few 100 ohms 15 watt resistors were just what I needed. So I took 6 of them and made a simple, single-sided PCB that holds the resistors as well as 6 switches.

_MG_0937

The resistors are upright and have a bit of an air gap between them. That’s important, they get incredibly hot with 36 volts accross them. I know, I had to learn the hard way 😉

_MG_0938

Together with the aluminium front it has a nice weight for its size and with it’s silicone feet it sits firmly on the bench.

_MG_0939