This is likely the first ham radio related project that I document here on this blog. But my very first PIC project was a beacon keyer that I made for my father, HB9BBD. That was was in 2013. A beacon keyer is a great project to get started with microcontrollers since it’s not much more than a fancy way of blinking an LED.
Over the last few weeks I have been quite busy with my MPPT Solar Charger project. I’ve built up a first board and started writing firmware for it. Since the last version was not too different in terms of hardware I was able to re-use most of that code. But I hadn’t even touched on the whole USB stuff back then so there was still a lot of work to do. While the project is still far from being complete I am happy to say that I’ve made quite some progress. Most importantly, the new design seems to work well and so far I haven’t found any mistakes in the board layout. But let’s go through this step by step.
Over the last year or so I’ve designed, built and tested a standalone solar charger. It performed quite well but as with any complex design there were a number of things that needed to be improved. So I eventually reached the point where I decided to design a revised version. And this is what this post is all about.
In my last post of this series I’ve looked at different transducers and finally decided on a entirely waterproof 14mm model. The much lower signal level from those kind of transducers makes it necessary to reduce the distance between the transducers in order to still receive a reasonable signal amplitude. So I took my previous lasercut design and reduced it in size so that the distance between the transducers is only 120mm. I went to the local FabLab and and lasered two copies of the downsized design.
In late 2014 and early 2015 I had posted a short series on an inductance meter project. The first post in that series described an Arduino shield that allowed an Arduino UNO to do inductance measurements and got this blog mentioned on dangerousprototypes.com for the very first time.
It’s been way too long since the last post in my Ultrasonic Anemometer series. But better late then never.
So far I have always used the same type of transducers. When I started this project I looked around and found the Multicomp MCUSD16A40S12RO. They were comparatively cheap and readily available so I ordered some and used nothing else for the next two or so years.
It’s time to follow up on the MPPT Solar Charger project. Progress has been slow since I’m currently working full time and doing a master’s degree at the same time. Given that this blog has previously been something close to a 50% job at times things will necessarily slow down a bit. But all the projects, including this one and the ultrasonic anemometer are alive and well and I’m working on them whenever I find some time.
As you may have noticed I’m quite busy working on the MPPT Solar Charger project. The latest version uses a 4 lines x 20 characters LCD that connects via I2C as well as a rotary encoder with a push button.
In a previous post I have presented a design for an MPPT Solar Charger. In the mean time I have built a prototype and also wrote some software for it. So today I’ll go through my findings of what works well and what needs to be improved. And yes, there are some flaws in the design…
I last time proudly presented the new RevB board and got a lot of feedback from people who want one, too. As mentioned I have all the components here to ship up to 10 kits but I was reluctant to send anything until I had the chance to do some hardware testing. Not much had changed since the last revision but I don’t like taking chances on things like this.
